NEJE 2 Series

How to know my control board version

Disassemble your control board from your device. The version mark usually marked on the front of the board. The following are examples of neje 2S and neje 2S max. the version of neje 2S control board in the figure is v1.1, The version of neje 2S Max control board is v2.0

How to work with Bluetooth

Install App: For Android: Download control software from download page. For iOS and macOS(10.15 required): Search and download NEJE Wireless from app store. How to connect bluetooth with NEJE device: Power on your device. what is my device state? Run app on phone. Wait automatic connection(about 5 seconds). FAQ: Ask: Can’t connect to my device …

How to work with Bluetooth Read More »

No response from device / all leds on / all leds off

If your device is out of response, you can try force reset firmware. For NEJE 1 series and NEJE 2 series device download Update_7.6.exe For NEJE 2S series device download Update_7.6.exe or Update_8.6.exe Then flash the NEJE firmware by How to flash NEJE firmware.(If progress stops at 1%, please see FAQ question 3).

About GRBL setting

ask: What can GRBL setting do? answer: GRBL setting can be used to customize your grbl device, like max rate, max travel…   ask: Where can I change GRBL setting? answer: Open LaserGRBL software, Menu->Grbl->Grbl Configuration. Like This:   For most customers, the following settings are useful: $110: Max rate of X $111: Max rate …

About GRBL setting Read More »

How to place your device correctly?

We found that sometimes users make mistakes about the correct orientation of NEJE device, the following is correct. For NEJE 2S and NEJE 2S Plus   For NEJE 2S Max   For all neje device, this is correct option at lightburn.

How to work with LaserGRBL

This page is only for NEJE 2S series. First: Prepare your device For NEJE Master 2 Serise device, we recommend baudrate 38400 firmware, so flash your firmware to 38400 baudrate. For NEJE Master 2S Serise device, We recommend baudrate 115200 firmware, so flash your firmware to 115200 baudrate. Make sure your device is at IDLE mode or …

How to work with LaserGRBL Read More »