Why Stepper Motor Making Noise at Stop ?
This page is moved to a new place: https://wiki.neje99.com/en/general/stepper-motor
Troubleshooting of KZ and BL
Please take a video of how the machine reacts when you press the switch button and send this video to us.
How to Adjust Belt?
There are two types of belt problems, too loose or too tight Too tight Too loose How to judge my belt is too tight ? Disconnect the wires from the motor first (this is important) and try moving the axis back and forth by hand, it shouldn’t be a lot of effort, for the X …
How to Adjust Belt? Read More »
How to Check My Cable Connection is Properly
This page is moved to a new place: https://wiki.neje99.com/en/manual/wiring
What is the Function of the Red Button?
This page is moved to a new place
Why Image is Incomplete
Got 3 bad run. Expected effect: Why? 450nm laser is not suitable for engraving on light colored materials. 450nm laser is easier to reflect than 405nm laser. When most of the energy is reflected, it cannot be engraved. Why is the missing piece by piece? When a piece has been burned, it will be easy …
Why Image is Incomplete Read More »
NEJE Control Software for iOS/macOS
NEJE 3 Support Device NEJE 3NEJE 3 PlusNEJE 3 ProNEJE 3 MaxNEJE Max 4 Support OS iPhone (iOS 10.0 or later)iPad (iPadOS 10.0 or later)Mac (macOS 11.0 or later) Go to App Store NEJE 2 Support Device NEJE BL 2019NEJE 2NEJE 2 PlusNEJE 2 MaxNEJE 2 miniNEJE 2SNEJE 2S PlusNEJE 2S Max Support OS iPhone …
NEJE Control Software for iOS/macOS Read More »
How to Know My Control Board Version
Disassemble your control board from your device. The version mark usually marked on the front of the board. The following are examples of NEJE 2S and NEJE 2S Max. the version of NEJ 2S control board in the figure is v1.1, The version of NEJE 2S Max control board is v2.0
Troubleshooting of GRBL
This article is only applicable to neje 2 / 2S series device, rename tips. In order to eliminate the influence of grbl setting (what is grbl setting), please flash the grbl firmware once before troubleshooting(How to flash grbl firmware). Connect to device： Download and install LaserGRBL, then connect to device. How to ? Test your …
Troubleshooting of GRBL Read More »
How to Test Homing at GRBL
Before testing, you need to know abot GRBL homing Step 1: Connect device with LaserGRBL Setp 2: Press homing button to start homing. FAQ: Homing button is not showing For NEJE Master 1/2 series device, auto homing is not supported, please homing manually. Homing fail Make sure you have reset grbl setting by flash grbl …
How to Test Homing at GRBL Read More »