Influenced Device Influenced Firmware Version Describe We found that when the customer runs lightburn on the Mac computer, the neje 3 series device will stop working, and then cannot connect and perform any actions. The cause of this problem is a firmware bug. This problem can be solved by updating the firmware Cause There is …
Emergency Fix for NEJE 3 Series No Response on Mac Read More »
Influenced Device Influenced Firmware Version Describe In GRBL mode, the output power of the laser does not match the setting. The following picture is the test result. It can be seen that the working result does not match the setting. After the repair is completed, the expected effect is as follows: Cause Because of a …
Emergency Fix for NEJE 3 GRBL Laser Output Error Read More »
If your device show like this: Please flash your NEJE firmware to the latest, Click here
This page is only for NEJE Master 2 serise. Looking for NEJE Master 2S? We found that the baud rate error of the neje Master 2 series device will cause the device stop working and cannot be connected. In order to solve this problem, we need to download the latest version of neje grbl uploader …
Solution of NEJE Master 2 Serises Device Stop Working Read More »
This page is only for NEJE 2S serise devices, Looking for NEJE Master 2 serises devices? If you have a problem of stopping halfway while using LightBurn or LaserGRBL, the general failure phenomenon is that the work cannot be completed, freezing, etc., this article should be helpful to you. First of all, please do a …
Solution of NEJE (Master) 2S Series Devices Stop Working Read More »